Product Introduction

	Horizontal	Vertical
Material	Tungsten Carbide	Tungsten Carbide
TPI	15-50mm	13-60mm
Application	Wood	Wood
Length	3500-12000mm	3500-15000mm
Thickness	0.7-1.5mm	0.7-1.67mm
Width	27-150mm	15-260mm
Kerf	1.3-3.0mm	1.3-3.2mm
Type	Woodworking	Woodworking
Note: Customized service available

Possible Problems & Solutions

PROBLEM :The surface of the cut board is uneven and deviatesREASON①: Deformation of the wheel surface

PREVENT/SOLVE①: the saw blade rubs against the wheel surface for a long time, and the wheel surface is not trimmed

REASON②: Rolling treatment is not good

PREVENT/SOLVE②: problems in the production of saw blades

REASON③: Angle mismatch

PREVENT/SOLVE③: production process problem, provide specific gravity of cut wood to production

REASON④: The knife

edge is not sharp

PREVENT/SOLVE④: it has not been ground for a long time

REASON⑤: Improper clamp (head) adjustment

PREVENT/SOLVE⑤: excessive clamp clearance

PROBLEM: Saw Blade crackedREASON①: Material Issues PREVENT/SOLVE①:Production Issues

REASON②:The knife edge is not sharp and the resistance is too large PREVENT/SOLVE②:the single use time is determined according to different materials to be cut

REASON③:Tooth profile mismatch PREVENT/SOLVE③:production problem

REASON④:Repair Grinding Cause PREVENT/SOLVE④:Incorrect Grinding

REASON⑤:Bad rolling handling PREVENT/SOLVE⑤:production problem

REASON⑥:Improper blade cooling PREVENT/SOLVE⑥:not cooling properly, or not cooling the bladeproperly

PROBLEM: Saw Blade breakREASON①: Material reason PREVENT/SOLVE①:production problem

REASON②:The knife edge is not sharp, and it has :been used for too long,and the resistance is too large PREVENT/SOLVE②: grind it on time

REASON③:The saw blade is rubbing against the equipment PREVENT/SOLVE③:adjust until the saw blade fits perfectly with the equipment

REASON④:Too much tension PREVENT/SOLVE④:choose thecorresponding tension according to the width and thickness of the saw blade

REASON⑤:The feed speed does not match

PREVENT/SOLVE⑤:according to the cutting of different wood, give the corresponding feed speed

REASON⑥:Human factors PREVENT/SOLVE⑥:wood ash notcleaned in time, grinding is not precise enough, manual feeding speed is uneven, key parts of the machine are regularly lubricated

Packaging & Shipping